Jamie poynton built a 14′ v hull stitch and glue, marine ply and epoxy outboard runabout, based on a v-shaped ski boat. the boat has clean, simple lines, a classically laid varnished mahogany deck, and jamie and rob murphy, jamie’s partner in the build painted it black and white with black carpet and white leatherette seating.. Skeeto replica build in stitch and glue, parts milled with cnc router from 9mm baltic birtch plywood. 4,5 meter long and 2,1 meter wide, hull weight 160 kg. 2012 summer. plans or kit are available.. Hull type: garvey vee bottom developed for stitch and glue sheet plywood or welded aluminum construction. power: single long shaft outboard motor to 85 hp maximum; 50 hp is more than adequate for most uses..
One of the most fun part is stitching and gluing the hull together. for that i drilled small holes in the mating panels and used cable ties to hold them tight.. Not sure whether this is the appropriate forum to ask these questions in, but here goes... when designing a stitch and glue hull for plywood composite construction and all developable panels, how can one predict how the plywood will bend?. Stitch-and-glue construction is a technique using marine plywood, wire, fiberglass cloth, epoxy fillers, wood flour and epoxy resin. the basic steps for the builder are to cut out the two bottom panels, the side panels and the transom these parts are then stitched together with wire along the panel seams..
0 komentar:
Posting Komentar